Training

Do sets or reps come first?

In this article

A large 2024 meta-regression by Pelland and colleagues analysed 67 studies with over 2,000 participants.

Reps come first. A rep is one complete movement, and a set is a group of reps done back to back before you rest. If your program says 3 sets of 10 on bench press, you lift 10 times, rest, lift 10 more, rest, and lift 10 more. That is 3 sets and 30 total reps.

The order matters less than what the two numbers do together. Reps set the type of stress on the muscle, and sets set how much of that stress you collect. Choose them badly and you train for the wrong goal. Choose them well and you build muscle and strength without wasting time in the gym. Pairing them with which form of exercise offers the greatest health benefits also helps you see where lifting fits in your week.

What is a rep?

A rep is one full movement of an exercise from start to finish. One squat down and back up is one rep. One bicep curl up and down is one rep.

Reps count how many times you move the weight before you stop. Heavier loads for fewer reps favour maximal strength. Lighter loads for more reps favour muscular endurance. Muscle growth sits across a wide middle range of both.

Research on rep ranges has found that muscle growth can be similar across quite different rep ranges when total training volume is matched and sets are taken hard enough. Reps are flexible, but each set still has to challenge the muscle.

What is a set?

A set is a group of reps done without stopping. When you finish your reps and put the weight down to rest, that is one set.

Most programs use 2 to 5 sets per exercise, and 2 to 3 sets suits most people. Beginners can start with 2 sets and add a third as they get stronger.

Weekly sets per muscle group are one of the biggest drivers of muscle growth. Meta-analyses, including Brad Schoenfeld’s 2017 work, found that people doing 10 or more sets per muscle group per week grew more than people doing fewer than 5.

How do you read a sets and reps prescription?

Programs rarely stop at 3 x 10. You will usually see a rep range, a load or effort target and a rest time, and each part tells you something.

  • 3 x 8-12: three sets, each ending somewhere between 8 and 12 reps. This is the setup for double progression, covered below.
  • 3 x 10 at RIR 2: RIR means reps in reserve. Stop each set with about 2 reps left in the tank.
  • 4 x 5 at 80%: four sets of five at roughly 80% of your one-rep max. This is common in strength work.
  • Rest 90s: the gap between sets, which is part of the prescription.

If a program gives only sets and reps with no effort guide, add your own. Choose a weight where the last 1 to 3 reps of every set are hard but your form holds. A set that you could do 10 more reps on is not doing the work the numbers imply, whatever it says on paper.

How many reps should you do for muscle growth?

For muscle growth, aim for 6 to 12 reps per set. That usually means a weight around 60% to 80% of your one-rep max. It gives you enough load to recruit lots of muscle fibres and enough reps to accumulate quality volume without a long grind.

Reviews of hypertrophy research consistently put this range among the most efficient. Major exercise guidelines point beginners towards roughly 8 to 12 reps for general muscle development. Studies of women’s strength training have shown the same result seen in men: moderate to heavy loads in the 8 to 12 range produce real gains in strength and muscle size.

The range is wider than most people think. Research shows you can build muscle with loads anywhere from about 5 reps to 30 reps, provided each set is taken close to failure. Studies comparing heavier 8 to 12 rep work with lighter 20 to 25 rep work found similar muscle gain when both groups pushed to the point where they could barely do another rep.

So effort matters more than the exact rep count. But 6 to 12 reps remains the most time-efficient choice for most people, because heavy-ish sets reach hard effort quickly. Very light sets take a long time and can end because of burning discomfort and not because the muscle is spent.

How many reps build strength?

For pure strength, train in the 1 to 5 rep range with heavy loads, about 80% to 100% of your one-rep max.

Reviews comparing loads have found a clear relationship between load and strength gains. People training in the 1 to 5 rep range tend to gain more one-rep max strength than people training in the 8 to 12 rep range, and the gap widens the longer you train. As you approach your strength ceiling, heavy loads matter more.

Heavy, low-rep lifting trains your nervous system to recruit more muscle fibres at once. This neural adaptation drives much of the strength you gain in the early months. Rest 2 to 5 minutes between sets so you can lift heavy again.

Strength also does not need huge volume. Meta-regression work suggests the useful range is a modest number of hard sets per muscle group per week, with gains flattening out quickly beyond that. Strength comes from high intensity more than high volume.

That said, very low reps are not for everyone. We steer beginners away from them. Sets of 1 to 3 are hard on technique and the nervous system, and they suit intermediate lifters who already move well under load. If you are newer to training, we would rather you work at 6 to 8 reps with a heavy weight than go lower. You still get a strong stimulus, with far more room to practise the movement.

How many sets per week do you need for muscle growth?

For muscle growth, aim for roughly 10 to 20 sets per muscle group per week.

A large 2024 meta-regression by Pelland and colleagues, covering dozens of studies and over 2,000 participants, found that muscle growth rises with weekly volume but with diminishing returns. Measurable growth showed up from around 4 sets per muscle group per week, and the benefits kept building into the mid-teens to around 20.

Beyond that range, extra sets tend to add fatigue faster than they add muscle for most people. More is not always better.

In practice, if you train chest twice per week with 4 exercises of 3 sets each across those two sessions, that is 12 sets for chest, well inside the effective zone. Remember that compound lifts overlap: bench press also works shoulders and triceps, so those muscles collect volume too.

What is double progression and why does it matter?

Double progression is the most practical way to use reps and sets together to keep improving.

Pick a rep range, say 8 to 12. Start with a weight you can lift for 8 reps with good form. Each session, try to add a rep. When you can do 12 reps on every set, increase the weight by 2.5 to 5 kg and drop back to 8 reps. Then build up again.

You progress in reps first, then cash that progress in for a heavier weight. This matters because your body adapts quickly. If you bench 60 kg for 3 sets of 10 every week, your muscles have little reason to grow after the first few weeks.

A simple example: curl 20 kg for 10 reps and you have moved 200 kg in that set. Next week, 20 kg for 11 reps moves 220 kg. That is a new stimulus without touching a heavier weight. Once you hit 12 reps on every set, move to 22.5 kg, go back to 8 reps, and start the cycle again.

Should you increase reps or add more sets first?

Increase reps first, then weight. Only add sets if progress stalls on both.

The order of priority:

  1. Add reps with the same weight (double progression)
  2. Add weight when you hit the top of your rep range
  3. Add sets per exercise if progress stalls
  4. Slow your reps down (tempo training) for a new stimulus
  5. Improve your range of motion and technique

Adding sets is powerful but costs more recovery than adding reps. Going from 5 to 10 weekly sets can add a lot of growth, but in the 20 to 30 set range returns drop off and fatigue climbs. A good rule is to raise volume by no more than 10% to 20% per week.

If you do 10 sets of chest per week and progress stalls, add one set to each exercise the next week. Keep going until you reach 20 to 25 weekly sets at most, then drop back to your original volume and start again. Pay attention to how tired you should feel after a workout: pleasantly worked is the goal, not wrecked for days.

Do beginners need the same sets and reps as advanced lifters?

No. Beginners grow with less volume and add weight faster than advanced lifters.

If you are new to lifting, almost any reasonable stimulus works. Start with 2 sets per exercise in the 10 to 12 rep range, with a weight that feels challenging but doable. Use enough weight that the last 2 reps feel tough while you still have 1 or 2 left in the tank.

Beginners can often add 2.5 to 5 kg to the bar each week on big lifts like squats, bench press and deadlifts. This straight-line progression usually works for the first 6 to 12 months.

Which end of the range suits you also depends on temperament. One client we coach told us she finds higher reps more motivating because she is chasing a target number, while heavy, low-rep days feel like a lot of work for little reward. If that sounds like you, we lean your programming towards higher reps. A plan you enjoy and repeat beats a perfect plan you skip.

Advanced lifters need more volume and more creative progression. As training experience rises, you generally need to train closer to your one-rep max to keep gaining strength and need higher weekly set volumes to keep building muscle.

Research on trained lifters also shows that cutting volume sharply, even down to a fraction of normal training, can maintain muscle, for example in a calorie deficit. It is generally not enough to build new muscle.

How long should you rest between sets?

Rest roughly 60 to 90 seconds for lighter, higher-rep muscle work and 2 to 5 minutes for heavy strength work.

For sets of 6 to 12, shorter rests keep the session efficient. Many lifters now rest longer, around 2 to 3 minutes, on heavy compound lifts because it keeps performance high across sets. For heavy sets of 1 to 5 reps, give your nervous system 2 to 5 minutes to recover.

Keep your total session, including the warm-up, to about 60 to 70 minutes if you can. Beyond that, quality tends to slip and sessions become hard to recover from.

If you are short on time, supersets (two exercises back to back for different muscle groups) can cut your workout time considerably. Research on superset training has found strength and muscle gains similar to traditional training in much less time.

How do muscle fibre types affect your rep choices?

Different muscles may respond slightly better to different rep ranges because of their fibre makeup.

Type I (slow-twitch) fibres resist fatigue and respond well to higher reps. Calves, upper back and postural muscles tend to have more of them, so sets of 12 to 20 or more often suit these areas.

Type II (fast-twitch) fibres generate more power and respond well to heavier loads. Quads, hamstrings and chest tend to have more of them, so sets of 6 to 10 with heavier weight are a good fit. Shoulders have a more even split and benefit from a mix.

The evidence for muscle-specific rep ranges is weaker than for the basics of effort and volume, so treat it as fine-tuning. Periodization is an easy way to cover both: for example, 3 to 4 weeks at 4 to 8 reps with 3 to 4 sets and longer rests, then 3 to 4 weeks at 8 to 15 reps with 2 to 3 sets and shorter rests.

How much does all this cost?

You do not need expensive equipment. A basic gym membership in Australia runs roughly $15 to $30 AUD per week. Adjustable dumbbells for home training cost around $150 to $400 AUD and cover most beginner exercises. A full set of resistance bands starts at about $20 to $50 AUD.

Online coaching typically runs $50 to $200 AUD per month depending on personalisation. If you would rather have someone watch your technique in person, a personal trainer in Rosebud can set your sets, reps and progression around your goals and teach you the movements properly. Many free double progression programs also work well for beginner and intermediate lifters.

FAQ

1. Do you count reps or sets first when working out? Reps first. Each rep is one movement. When you finish all your reps, that completes one set. Then you rest and start the next.

2. What does 3 sets of 12 reps mean? You do 12 reps, rest, do 12 more, rest, and do 12 more. That is 3 sets and 36 total reps.

3. Is it better to do more sets or more reps? For muscle growth, more weekly sets (up to about 20 per muscle group) generally beat simply adding reps to existing sets. If you already do enough sets, adding reps through double progression is the easiest way to progress each session.

4. Can you build muscle with high reps and light weight? Yes. Research shows sets of up to about 30 reps can build muscle if you push close to failure. The weight matters less than the effort.

5. How many sets should a beginner do per workout? Start with 2 to 3 sets per exercise and roughly 5 to 8 exercises per session. Across the week, aim for about 10 to 12 sets per muscle group.

6. What rep range burns the most fat? No rep range burns meaningfully more fat than another. Fat loss comes from eating fewer calories than you burn. Any rep range that builds or maintains muscle during a calorie deficit helps, and exercise improves insulin sensitivity and other health markers even without weight loss.

7. How often should you change your rep range? Every 3 to 4 weeks works for most people. Rotating between heavier, lower-rep phases and lighter, higher-rep phases keeps training fresh and works both fibre types.

8. Is training to failure necessary for muscle growth? Not on every set. Leaving 1 to 2 reps in reserve on most sets is enough to stimulate growth while managing fatigue. Taking the last set of an exercise to failure can add stimulus without burning you out. Most people underestimate how many reps they have left, so if you think you have 2 left, you may have more.

9. How do you know when to increase weight? When you hit the top of your rep range on all sets with good form, raise the weight by the smallest step available, usually 2.5 kg for upper body and 5 kg for lower body lifts. Dropping below the bottom of your range with the new weight is normal. Build back up.

10. What happens if you do too many sets? Performance drops, recovery suffers and workouts get longer without extra benefit. Returns diminish beyond about 20 sets per muscle group per week for most people. If you feel constantly sore or tired, or your strength is going backwards, cut volume by 30% to 50% for a week (a deload), then build back up.

armstrong author profile (1)

Armstrong Lazenby

Armstrong Lazenby is a BSc (Human Nutrition) registered nutritionist and holds a Bachelor of Science in Exercise Science and a Master of Sports Medicine. A former professional athlete who competed representing Australia for 4 years, Armstrong has held scholarships with the Victorian Institute of Sport, Australian Institute of Sport, and the Olympic Winter Institute of Australia.

Qualifications:
• BSc (Human Nutrition) — Registered Nutritionist
• Bachelor of Science (Exercise Science major)
• Master of Sports Medicine
• Certificate III & IV in Fitness